Render Scratching Float 250 x 140mm D-Grip Steel Barbs

A render scratching float used for keying base coats before the next layer is applied. The 250 x 140mm working face is fitted with 8mm zinc-plated steel barbs, while the D-grip handle gives a secure hold during rendering and plastering work.

Used by plasterers, renderers and tradespeople, this float helps roughen up fresh base coats so following coats have better grip. It is suitable for rendering jobs, patch repairs, wall preparation and general plastering work where a scratched finish is needed to improve adhesion between layers. It is also useful for smaller maintenance jobs at home or on site where a clean, even key needs to be put into the surface by hand.

The size gives a practical balance between coverage and control, making it easier to work across flat areas without feeling too cumbersome in the hand. The D-grip handle helps with steady handling when pulling the float across the surface, especially on repeated passes. Zinc-plated 8mm steel barbs are there to create the scratch pattern needed for improved grab and adhesion. For regular rendering and plastering work, it is a straightforward hand tool to keep close by when preparing coats properly.

Render scratching float specifications

• Size: 250 x 140mm float face for controlled coverage on render and plaster surfaces.
• Handle: D-grip design for a secure hand position during use.
• Barbs: Fitted with 8mm steel barbs to scratch and key base coats.
• Finish: Zinc-plated barbs help provide improved grab and adhesion.
• Application: Suitable for rendering and plastering work where a keyed surface is required.

A practical choice for regular rendering, plastering and repair work.