Cylinder Hone 94-96mm 120 Grit Flexible Engine Bore Honing Tool

A flexible cylinder hone for 94-96mm bores, used to clean up and refresh the internal surface of engine cylinders and similar internal diameters. The 120 grit abrasive gives a controlled cutting action for general honing and light deglazing work, while the flexible design helps it follow the bore more naturally during use.

Used in garages, workshops and engineering environments, this type of bore honing tool is handy for engine rebuilds, servicing and repair work where the cylinder surface needs attention before reassembly. It suits general maintenance jobs on engine bores as well as other internal surfaces within the stated size range, especially where a rigid hone may be less forgiving. For vehicle maintenance and workshop use, it helps when you need to remove light glazing and improve surface condition without awkward handling.

The working range covers 94-96mm bores, making it easier to match the tool to the job in hand. A 7.8mm shaft is fitted for the required tool setup, and the maximum running speed is 300rpm, which should be observed so the hone performs as intended and avoids unnecessary wear. The flexible style is useful when working through the bore evenly, helping achieve a more consistent finish across the internal surface. For regular rebuild and refresh work, it is a practical option to keep close by when common cylinder preparation jobs come up.

Cylinder hone specifications

• Working range: Suits bores from 94mm to 96mm.
• Abrasive grade: 120 grit for general honing and light deglazing.
• Shaft size: Fitted with a 7.8mm shaft.
• Speed limit: Should be run at no more than 300rpm.
• Design: Flexible hone follows the internal surface more naturally during use.

A practical choice for regular maintenance, rebuild and cylinder preparation work.