Masons Peg 300mm Dutch Pin Steel Masonry Clamp

A 300mm masons peg used for temporary fixing when working against plaster and most masonry surfaces. This Dutch pin masonry clamp gives a simple way to hold boards, profiles and guides in place while you line up and level the job.

Used by bricklayers, plasterers and general trades, it suits setting up temporary guides before final fixing. It is handy for wall work where boards or profiles need holding in position during levelling, marking out or alignment, and it also helps on repair and renovation jobs where quick temporary support is needed without relying on nails.

The steel shaft is corrosion resistant and made for repeated site and workshop use where tools and fixings are regularly exposed to dust, plaster and general damp conditions. At 300mm long, it gives a practical reach for tapping into the surface and adjusting the position before a final hammer tap tightens the hold. Release is straightforward as well, with the outer end tapped to loosen it again, which is useful when you need to move guides or remove temporary supports without wasting time. For anyone carrying out regular masonry or plastering work, it is a straightforward way to keep set-up and alignment jobs moving.

Masons peg specifications

• Length: 300mm peg size for temporary fixing and positioning work.
• Material: Steel shaft with a corrosion resistant finish.
• Application: Used for boards, profiles and guides fixed temporarily to walls.
• Use: Suitable for hammering into plaster and most masonry work.
• Function: Holds firmly for levelling, then releases quickly by tapping the outer end.

A practical choice for regular masonry, plastering and fitting work.