Slogging Spanner 24mm 12 Point Striking Wrench 3/4in Drive

A 24mm striking wrench built for heavy fastening work where extra force is needed. This slogging box end wrench has a short, thick body with a block striking end, allowing hammer blows to be applied when working on tight, seized or high-torque fasteners.

Used for commercial brake calliper work on front and trailing axles, it allows assembly and disassembly without removing the steering tie rod. It is also suited to workshop use, vehicle maintenance and repair jobs where large nuts and bolts need shock force to free them, or where access is too limited for a longer wrench. The 12-point box end helps when aligning onto fasteners, while the square drive adds another practical option when the job calls for it.

The stocky pattern is made for confined working areas where a large wrench cannot swing properly. Two striking faces are provided for hammer use, helping transfer force directly through the wrench onto stubborn fixings. The central 20mm / 3/4in square drive is useful where additional drive options are needed during brake servicing or heavy fastening work. This type of wrench is also commonly used on indexed nut and stud applications where controlled tightening by mark count is required. For regular garage or commercial vehicle maintenance, it is a practical tool to keep close to hand when seized fasteners are likely to slow the job down.

Slogging wrenches specifications

• Size: 24mm box end for matching large fasteners.
• Drive: Central 20mm / 3/4in square drive built into the wrench.
• End type: 12-point box end helps with positioning on the fastener.
• Striking faces: Two striking faces for hammer use when extra force is needed.
• Application: Commonly used for commercial brake callipers, seized nuts and restricted-access fastening work.

A practical choice for regular maintenance and repair work where extra force is sometimes needed.