SDS Plus Drill Bit 10 x 210mm Cross Cutter for Concrete

A 10 x 210mm SDS Plus drill bit built for drilling into concrete and masonry with an SDS-plus hammer drill. The cross cutter tip helps keep the cut working cleanly and supports a more accurate hole diameter, which is useful when fixings need to sit properly.

Used for anchor holes, fixing holes and clearance holes in site work, installation jobs and general repair work, this bit suits builders, electricians, plumbers and maintenance trades. It also makes sense for garage, workshop or van stock where an SDS-plus drill is already part of the kit, especially when working on masonry fixings, brackets, cable runs or pipe supports.

The SDS-plus shank fits hammer drills that use that holder, so changing over is straightforward when moving between drilling tasks. With a 10mm diameter and 210mm overall length, it gives more reach than a shorter bit where access or drilling depth calls for it. The cross cutter tip is intended to keep the bit cutting actively in concrete while helping maintain the correct hole size. That can save time on repeated fitting work by helping produce neater holes for common fixings and anchors.

SDS plus drill bits specifications

• Size: 10mm diameter with 210mm overall length.
• Tip design: Cross cutter tip helps keep the cut clean and active in concrete.
• Fitment: SDS-plus shank fits hammer drills that use an SDS-plus holder.

SDS drill bits: drilling applications

• Application: Useful for drilling anchor, fixing and clearance holes in concrete and masonry.
• Use case: Suits trade work, repair jobs and regular site installation tasks.
• Drill fitment: This bit fits hammer drills that accept SDS bits with an SDS-plus shank.

A practical masonry drill bit for regular concrete drilling work.