Air Hammer Drift Set 6pc Long Reach 10mm Shaft for Laser

A 6-piece air hammer drift set for driving out stuck shafts, screws and similar components where standard-length drifts cannot reach properly. Built for use with a Laser air hammer, it gives you a practical range of long reach drift sizes for awkward workshop jobs.

Used for garage work, fabrication and general mechanical repair, this set helps when parts are recessed deep inside a housing or set back in a bore. It is especially useful during vehicle maintenance and workshop servicing where seized parts need controlled removal with better access than a normal punch can provide. When working on awkward extraction jobs, the longer drift length helps reach components that would otherwise be difficult to move safely and cleanly.

The set includes six commonly used drift sizes, covering smaller and larger jobs without reaching for unrelated tools. Each drift uses a 10mm round shaft, so the fitting style stays consistent across the full set, which also makes them simpler to organise between jobs. For regular repair and maintenance work, having matching long reach drifts close to hand can save time when access is limited and a standard setup will not get far enough in.

Air hammer drift set specifications

• Contents: 6-piece drift set for air hammer use.
• Size range: Includes 5.2, 6.5, 6.9, 7.7, 9.3 and 12.7mm drifts.
• Fitment: 10mm round shaft across all pieces.
• Application: Useful for removing stuck shafts, seized screws and similar parts.
• Design: Long reach drifts help with access into deep holes and recessed areas.

A practical choice for regular maintenance and repair work.